Hoe maak je deze prachtige lamp
1) The first thing you will want to do is drill three holes in your bracket. There are two pre-drilled holes at the top of the bracket which we just widened and the third hole was drilled into the bottom portion of the support/angled piece of the bracket in line with the predrilled hole at the top of the bracket. In the photo above you can see where the three holes are.
2) Next you will need to cut off the plug end and the switch portion of the pendant light with wire snips so that you can thread the cord through the bracket starting at the outermost hole and going up over the top of the bracket and down through the bottom hole.
3) Have an electrician install a new plug on the end of your light fixture. Tech Guy has experience with electrical work and works with electricians and therefore was able to do this himself, but I can't give you a tutorial on this since we are not licensed electricians. Once the light is wired, you're ready to plug your light in and enjoy your new sconce!
From:https://www.nalleshouse.com